Car Video

A few years ago that the installation of a touchscreen monitor in the car is something that neither had seen in films or on those incredible deception of vehicles, specially built for science fairs. Almost all newer cars come with them factory installed, or at least can be installed after the market rather easily. Through this study, a driver can program their GPS navigation system, Bluetooth, and have them check all the stereo channels, all with the touch of yourfingertips.

There are several ways to put this car. The two most common setup is an in-dash factory look of the car. So is the set that uses a motor frame window folds out from the dashboard and then in a growing and prominent position. Here is a step by step description of how you can install a system of touch-screen display in the car on their own.
The first thing to do is look at yourdashboard and find out if this is a double DIN installation of the device is your setup. It 'pretty easy to spot if you know what you're looking for. Double-DIN configuration for the dashboard of your car will provide a system of touch-screen display that is flush with the dashboard assembly. A single-DIN configuration does not allow this, and you need a screen that turns up to install.

Make sure you have all the right tools to go ahead with the installation kit and wiring harnesspre-purchased. Any place that sells car audio systems installation or service purchased. If the vehicle does not have an installation created for it, then roll your sleeves, because you have a job for you in terms of changes in your dashboard.

Now you need to get under the hood to drive the battery cables from the battery. You must use the correct size tools necessary to take care of this.

TakeThe old head unit out. Depending on the brand of car, you should probably remove a few dash panels to do it. The old main unit will be held there with screws. Pull it out and the stereo should slide right out of the dashboard. Once off, unplug all cables from antenna.

Now that you have all the old equipment out of the car begins to install all new hardware and the touch screen with the installation. Seating iscertainly in the series, so do not slip out and possibly break.

Now that the monitor is ready to enter the plant and is ready to bring on line, all lines of the car for wiring installed, which already belongs to the touchscreen display. Connect audio / video cable to the monitor manual and always if you are not sure where to look.

Ok. You have the line ready to go. Now youThe installation of the screen back into the dashboard. Of all the stages are the easiest, because it is almost the last. Safe driving tightening all the screws and replace the dash when you have finished it.

Connect the battery cables back up and start the machine to test the screen. If everything went smoothly during the installation, the lights display.

Related posts:

1. Up to install a TV tuner in your car for a simple project
2. How to Install Car Audio Wires and cables
3. As iPod Your Car
4. Mobile Multimedia – a new peak in the Alpine Car Stereo
5. Car Stereo Wiring 101 – a must read!
6. Installing Aftermarket Head Units
7. Car Audio Amplifiers
8. Differences between car stereos cheap, expensive
9. Car Audio – from your computer to your car – Part 2 – Connect your MP3 player
10. 8-Car DVD Kit Player Portable Toshiba

Comments are closed.